Cylinder, 2in Bore x 14in Stroke for MacNeil

ITEM #: 20002875 BRAND: SMC Corporation of America

$274.72

Quantity:

Adding to cart… The item has been added

Have a Question?

Specifications

used on:

Cylinders and Shocks/Cylinders

Detail

Detail Header Lorem Ipsum

Lorem ipsum dolor sit amet, consetetur sadipscing elitr, sed diam nonumy eirmod tempor invidunt ut labore et dolore magna aliquyam erat, sed diam voluptua. At vero eos et accusam et justo duo dolores et ea rebum. Stet clita kasd gubergren, no sea takimata sanctus est Lorem ipsum dolor sit amet. Lorem ipsum dolor sit amet, consetetur sadipscing elitr, sed diam nonumy eirmod tempor invidunt ut labore et dolore magna aliquyam erat, sed diam voluptua. At vero eos et accusam et justo duo dolores et ea rebum.

Sonny's Replacement Air Cylinder and Extension Rod For Ryko® and MacNeil®

Bore & Stroke: 2in Bore x 14in Stroke
Rod Thread: 7/16in-20 UNF
Rod Mounting: Rod Eye
Rear Mounting: Female Clevis
Port Size: 3/8 NPT Ports
Used On RS600

How To Measure Cylinder

Primary arm / exit side
Used on: RS600

Item No.	McNell No.	Description
20002875	90-100-03-PP	Sonny's Replacement Cylinder, MCN 2in Bore x 14in Stk SMC

How to Measure your Cylinder's Stroke:

To determine your cylinder's stroke, measure the rod fully extended including, the bolt-on rod wiper (see below). DO NOT include the exposed unthreaded rod when fully retracted or the threaded section. i.e. (Cylinder shown has a 2in Bore x 6in Stroke).

How to meausre your cylinder's stroke diagram

How to Determine Cylinder Bore Size:

Linear cylinders typically fall into two categories involving either a round body (repairable or non-repairable) or a tie rod type (repairable).

The best method for measuring round body cylinders is measuring the O.D. of the tube or center section of the cylinder not including the end caps.

The tie rod cylinders can be measured based on the square dimension of the body. The body dimensions can vary by manufacturer but the measurement will provide a reasonably accurate determination of the proper bore size.